Computer Hardware Support - Re: New RAM causing a strange boot problem...
> My Gigabyte board does not have a CMOS jumper. To clear the CMOS, you
remove
> the battery located near the BIOS chip. Do this with power off (disconnect
> power supply). Leave the battery out for at least 30 seconds. Replace,
> reconnect power, reboot into BIOS and set your preferences.
>
> "Support only 2.5 V DDRAM" may be part of the problem. Depending on the
type
> of RAM you are using, it may need more than that. I'm running 1GB Mushkin
> PC3500 and had to up the V from 2.5 to 2.6 to get it to run stable.
>
>
>
> Fitz
>
>
posted by crash @ 2:02 AM
0 Comments:
Post a Comment
<< Home